By Juan Cordon
Make the Columns yourself
Here is the realization
60mm diameter galvanized tube
Drill the tube for the pulley axis
Here are the pulleys in place
Fixing of the 2 tubes on an aluminum profile
Here is the structure that supports the 2 columns
I fixed it on a U-shaped aluminum profile
Installation of the profile supporting the depth potentiometer
Diagram of the potentiometers for the connection to the joystick port from the pc or via an interface eg: USBaxe from Opencockpits or leobodnar bu0836a
And here are my 2 columns on the support
I prepare the support for the connections
1)Trim vertical --2)Trim horizontal-- 3) PA --4) lighting
Note the system of pulleys and steel cables for the transmission of movement to the 2 yokes
This part in blue will be covered with a mask