By Juan Cordon
Make the Yokes yourself
Here is the realization
Construction of flight controls (Yoke)
-- Plan
I use MDF panels, for the lower part of the 9mm and 24 mm for the upper part.
The screws are placed on the 9mm panel which in fact will constitute the back of the control
And here are my 2 cut yokes, but far from finished
I can't resist the temptation to see what it looks like on the columns
It is still necessary to rework all the roundings, file, sand, reline and re-sand
It's starting to take shape, not bad isn't it?
Rear view
Applying a coat of primer
After drying, it will be necessary to sand back to have a smooth finish and then apply a coat of black paint
It remains to place the buttons and the wiring as already seen above
Move the mouse out of the frame